| 1. | 4 programing of transient simulation software of salient pole synchronous generator armature winding internal faults
而正确的参数计算的结果，是正确仿真计算的关键。 |
| 2. | Enclosed low - voltage switchgear and controlgear assemblies - guide for testing under conditions of arcing due to internal fault
封装的低压开关和控制装置.内部错误引起的电弧放电条件下的试验指南 |
| 3. | Enclosed low - voltage switchgear and controlgear assemblies - guide for testing under conditions of arcing due to internal fault
封闭式低压成套开关设备和控制设备在内部故障引起电弧情况下的试验导则 |
| 4. | The stator ' s internal faults , which often occur in the synchronous machine , will cause serious damages to machines and power system
同步电机的定子绕组内部故障是电机中常见的破坏性很强的故障。 |
| 5. | How to discriminate between internal fault and magnetizing inrush current is the difficulty of transformer protection when apply differential relay
变压器主保护选择差动在原理上存在不足，带来的问题就是如何准确鉴别励磁涌流与内部故障，这也是目前变压器保护的难点。 |
| 6. | The technique can distinguish external fault , internal fault and switching on slight fault , without information concerning parameters of the transformer and power system is required
该方法能迅速有效的区分区外故障与区内故障，以及空载合闸于轻微故障的故障电流。 |
| 7. | Enclosed low - voltage switchgear and controlgear assemblies - part 1 : typetested and partially typetested assemblies ; technical report : guide for testing under conditions of arcing due to an internal fault iec 61641 : 1996
封闭式低压开关和控制装置.第1部分:型式试验和部分型 |
| 8. | In order to predict the destructive effects of internal faults and design the protection schemes , the behavior of machine after internal faults should be analyzed in detail
为了预测故障的破坏程度、设计机组的内部短路保护方案以减轻故障损害，都需要对绕组故障时的运行状态做详细的分析。 |
| 9. | 6 the laws governing the internal faults are investigated . this has provided theoretic foundation to the configuration and optimization of protection for synchronous generator with internal armature winding faults
本文所讨论的虽然是凸极同步发电机，但是其结构具有一定的代表性，隐极同步发电机可以作为特例用类似的方法分析。 |
| 10. | By means of the multi - loop method , the steady - state analysis of internal faults in stator windings of synchronous machine has been made , but as to the transient analysis , research only limited to single machine with no - load
运用多回路方法，已经基本解决了同步电机内部故障的稳态分析问题，但对故障的暂态研究，以前还仅限于单机空载的情况。 |
